Get a quote
Homeowner guides · San Francisco Bay Area

Straight answers about structural work on Bay Area homes.

Thinking about opening a wall, retrofitting, adding an ADU or fixing a foundation? Start here. These guides are written by Bay Area Structural Engineers, a licensed engineering firm in San Francisco.

Do I need a structural engineer?

You need one whenever a project changes how your house carries weight or resists earthquakes and wind. Cosmetic remodels usually don't. Anything that moves loads around usually does, and the city will often require stamped engineering before issuing a permit.

Projects that usually need an engineer

  • Removing or opening up a load-bearing wall
  • Seismic retrofits, including soft-story and cripple wall work
  • New foundations, underpinning or foundation repair
  • Additions, second stories and most ADUs
  • Large new openings for windows or doors in exterior walls
  • Heavy new loads, like rooftop decks or solar on older roofs

What you get

Usually a set of structural calculations and drawings, stamped by a licensed engineer, that become part of your permit submission. If the city's plan checker has questions, the engineer answers them in writing.

Not sure if your project needs one? Describe it and we'll tell you.Ask Bay Area Structural Engineers

Removing a load-bearing wall

Opening up a kitchen or living area is one of the most common projects in Bay Area homes. The key question is whether the wall is holding something up: a floor, a ceiling, or the roof.

How to tell if a wall is load-bearing

Clues include walls that run perpendicular to the floor or ceiling joists, walls stacked directly over other walls or beams, and walls near the middle of the house. Clues aren't proof, though. An engineer or experienced contractor should confirm before anything comes down.

What replacing it involves

  • A beam sized for the loads above, either dropped below the ceiling or flush with it
  • Posts at each end that carry the load down
  • A path for that load all the way to the foundation, which sometimes means new footings
  • Temporary shoring while the work happens
Planning to open a wall? Send photos and a rough floor plan.Get beam design & calcs

Seismic retrofits

Much of the Bay Area's housing is older wood-frame construction built before modern seismic codes. Retrofits strengthen the weak points that tend to fail in an earthquake.

Common retrofit types

  • Foundation bolting: anchoring the wood frame to the foundation so the house can't slide off.
  • Cripple wall bracing: stiffening the short walls between the foundation and the first floor.
  • Soft-story retrofits: strengthening ground floors with large openings, such as garages and storefronts under living space. Several Bay Area cities, including San Francisco, have programs requiring this for certain buildings.

Your city's building department can tell you whether your building is on a mandatory retrofit list. Even when it isn't required, a retrofit can make sense for safety and peace of mind.

Have a retrofit notice or just want to be safer?Talk to an engineer

Foundations

Hairline cracks in concrete are common and often harmless. Wider cracks, cracks that keep growing, sticking doors and windows, or sloping floors can point to settlement that deserves a closer look.

When to call an engineer

  • Cracks you can fit a coin into, or that are offset on one side
  • Floors that have started sloping or doors that suddenly stick
  • Before buying an older home with visible foundation issues
  • Before adding a story or heavy new loads

An engineer can tell the difference between normal aging and a real problem, and design repairs or underpinning when needed.

Worried about a crack? Send a few photos.Request an assessment

ADUs & additions

Garage conversions, backyard cottages, in-law units and second stories are popular ways to add space across the Bay Area. Almost all of them involve structural work.

Typical structural questions

  • Can the existing foundation handle the new use or added weight?
  • Does a garage opening need a new beam or seismic strengthening?
  • How will a new second story tie into the house below?

Bringing an engineer in early, alongside your designer or drafter, avoids redesigns once the city starts reviewing.

Planning an ADU or addition?Get structural design

Permits & plan check

When you submit plans for structural work, the city reviews them in a process usually called plan check. It's normal to get comments back asking for clarifications, extra details or revised calculations.

How to keep your permit moving

  • Submit complete structural calculations and drawings the first time
  • Respond to every plan-check comment clearly and in writing
  • Make sure the architectural and structural sheets agree with each other
Stuck on plan-check comments? We respond to them for you.Get help with plan check

Quick answers

Do I need a structural engineer to remove a wall?

If the wall is load-bearing, almost always yes. An engineer sizes the beam, posts and connections that replace it, and the city will usually ask for stamped calculations with your permit.

What does a structural engineer provide for a permit?

Typically stamped structural calculations and structural drawings that become part of your permit set, plus written responses if the plan checker has comments.

Who writes these guides?

Bay Area Structural Engineers, a San Francisco firm. The engineer of record is Fady Bou Shebel, California Licensed Civil Engineer C89004.

How do I start?

Send the property address, a short description and any photos or plans through the quote form, or email wissam@bayareastructuralengineer.com.